DasMikro TBS Mini Sound Unit V3

DasMikro TBS Mini Sound Unit V3

Description:

This sound unit is developed for all kinds of RC controlled models, including trucks, crawlers, tanks, airplanes…

New features:

– 16x larger sound memory, enough for 28 Minuts of sound

– Powerful 3W digital amplifier on board

– 4OHm and 8Ohm speakers can be used

– Volume controller on board

– New connector for 3rd party amplifiers -> See manual !

– Dimension is 3mm wider than the former TBS Mini V1

– Receiver supply must be in the range of 4V – 6V(max) !!!

Additional features:

– Fully customer programmable

– Large FREE OF CHARGE sound libraries of original recordings

– Sound quality 22KHz

– 16Mbit Sound memory, enough for 93s of sound recordings

– Internal 1,2W amplifier at 8 Ohm speakers

– External high power amplifiers connection possible

– Up to 6 electronic switching outputs

– External smoke generator for exhaust simulation

– Two digital inputs for triggering sounds by an external signal

– Two servo signal outputs, f.e. for retractable landing gears

– All connections done by plugs, no solder work necessary

– Receiver signals are used for speed information,  this allows brushless or DC Motor usage

– All connections horizontally -> full isolation and protection by shrink plastic tube possible

– Fully SMD technology (no heavy, vibration sensitive components)

– All wires included

– Very little dimensions and weight

– USB or RS232 programing interface by external adaptor (optional)

– Can be fully configured by free of charge PC software:

– You can make your own sound creation or using the original sounds

– Plays two sounds simultaneously (engine plus a special sound) from TBS Flash Ver. 1.0.1.0 on

Technical Spec:

Voltage supply range:  4V – max. 6V (from receiver)

Internal amplifier: 3W at 4 Ohm and 6V supply

Switching outputs: Minus switching, max. 12V/0,5A each

Dimensions: 55mm x 28mm x 10mm  (3mm wider than the TBS Mini V1)

Weight: about 6g

Package Included:

1 x DasMikro TBS Mini Sound Unit PCB V3

2 x 10cm 3P receiver connection servo cable

1 x 10cm 3P receiver connection servo Y cable (for tank second ESC speed input)

1 x 20cm 2P speaker connection cable

4 x 30cm 3P external switching connection cable

1 x test speaker

(Test speaker is only for sound unit test, you need to prepare the high quality speaker by yourself according to your projects request)

Wire Connection:

Pictures: